Below is a listing of projects past and present carried out by the Saint Lucia Bureau of Standards.
Electrodeposited nickel plus chromium coatings for automobile plastic parts－specification and test requirements
10.60 Close of voting
Meteorology — Radiosonde — Part 2: Test method for humidity sensor of radiosonde
10.00 Proposal for new project registered
An adhesion evaluation method for microcircuits on PCB (Printed Circuit Board) by scratch test
10.60 Close of voting
Composites and reinforcement fibres — Carbon fibre reinforced plastics (CFRPs) and metalassemblies — Combined stress testing
10.20 New project ballot initiated
Composites and reinforcement fibres — Carbon fibre reinforced plastics (CFRPs) and metal assemblies — Determination of adhesion joint shear properties by asymmetric four-point bending load
10.20 New project ballot initiated
Microbeam analysis — Analytical electron microscopy — The measurement of the dislocation density in thin metals
10.20 New project ballot initiated
Classification for discrete polymer fibre for fibre-reinforced cementitious composites
10.20 New project ballot initiated
Cutting tool data representation and exchange — Part 61: Company codes
10.00 Proposal for new project registered
Sludge recovery, recycling, treatment and disposal — Determination of calorific value of sludge
10.20 New project ballot initiated
Environmental management systems — Guidelines for using ISO 14001 to address environmental aspects and conditions within an environmental topic area — Part 3: Climate
10.60 Close of voting
Environmental management systems — Guidelines for using ISO 14001 to address environmental aspects and conditions within an environmental topic area — Part 4: Part 4: Resources and waste
10.20 New project ballot initiated
Validation and verification of sustainability information — Part 1: General principles and requirements
10.60 Close of voting
Validation and verification of sustainability information — Part 2: Verification process
10.60 Close of voting
Natural Capital Accounting for Organizations — Specification
10.00 Proposal for new project registered
Metallic materials — Charpy pendulum impact test — Part 4: Part 4: Testing of miniature Charpy V-notch test pieces
10.60 Close of voting
Ultra-low carbon high boron steel wire rod for copper cladded wire
10.60 Close of voting
Thermal performance of windows, doors and shading devices — Detailed calculations
10.20 New project ballot initiated