Below is a listing of projects past and present carried out by the Saint Lucia Bureau of Standards.
Preparation of steel substrates before application of paints and related products — Specifications for metallic blast-cleaning abrasives — Part 6: Stainless steel shot
10.20 New project ballot initiated
Preparation of steel substrates before application of paints and related products — Specifications for metallic blast-cleaning abrasives — Part 7: high chromium cast iron grit
10.20 New project ballot initiated
Radio frequency identification of animals — Code structure
10.20 New project ballot initiated
Paints and varnishes — Determination of volatile organic compounds(VOC) and/or semi volatile organic compounds (SVOC) content — Part 2: Gas-chromatographic method
10.60 Close of voting
Interior air of road vehicles — Part 12: Synthetic PVC or polyurethane leather — Specification and methods for the determination of fogging characteristics of trim materials in the interior of automobiles
10.60 Close of voting
Chemical analysis of lithium composite oxides — Part 2: Part2: Determination of trace elementsalysis of lithium composite oxides
10.20 New project ballot initiated
Chemical analysis of lithium composite oxides — Part 3: Part 3: Determination of lithium carbonate and lithium hydroxide contents
10.20 New project ballot initiated
Rubber, raw — Determination of water content by Karl Fischer method
10.60 Close of voting
Meteorology — Radiosonde — Part 1: Test method for temperature sensor of radiosonde
10.00 Proposal for new project registered
Electrodeposited nickel plus chromium coatings for automobile plastic parts－specification and test requirements
10.60 Close of voting
Meteorology — Radiosonde — Part 2: Test method for humidity sensor of radiosonde
10.00 Proposal for new project registered
An adhesion evaluation method for microcircuits on PCB (Printed Circuit Board) by scratch test
10.60 Close of voting
Composites and reinforcement fibres — Carbon fibre reinforced plastics (CFRPs) and metalassemblies — Combined stress testing
10.20 New project ballot initiated
Composites and reinforcement fibres — Carbon fibre reinforced plastics (CFRPs) and metal assemblies — Determination of adhesion joint shear properties by asymmetric four-point bending load
10.20 New project ballot initiated
Microbeam analysis — Analytical electron microscopy — The measurement of the dislocation density in thin metals
10.20 New project ballot initiated