Below is a listing of projects past and present carried out by the Saint Lucia Bureau of Standards.
Reaction to fire tests — Spread of flame — Part 1: Guidance on flame spread
90.93 Standard confirmed
Reaction-to-fire tests — Heat release, smoke production and mass loss rate — Part 3: Guidance on measurement
90.60 Close of review
Reaction-to-fire tests — Heat release, smoke production and mass loss rate — Part 4: Measurement of low levels of heat release
90.93 Standard confirmed
Reaction-to-fire tests — Heat release, smoke production and mass loss rate — Part 5: Heat release rate (cone calorimeter method) and smoke production rate (dynamic measurement) under reduced oxygen atmospheres
60.60 Standard published
Water quality — Sampling — Part 25: Guideline on the validation of the storage time of water samples
60.60 Standard published
In vitro diagnostic test systems — Requirements and recommendations for detection of severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2) by nucleic acid amplification methods
60.60 Standard published
Steel and steel products — Vocabulary relating to chemical analysis
60.60 Standard published
Traditional Chinese medicine — Categorial structure for disorders
60.60 Standard published
Calculation of load capacity of spur and helical gears — Part 20: Calculation of scuffing load capacity (also applicable to bevel and hypoid gears) — Flash temperature method
90.92 Standard to be revised
Calculation of load capacity of spur and helical gears — Part 20: Calculation of scuffing load capacity — Flash temperature method
60.60 Standard published
Calculation of load capacity of spur and helical gears — Part 21: Calculation of scuffing load capacity (also applicable to bevel and hypoid gears) — Integral temperature method
90.92 Standard to be revised
Calculation of load capacity of spur and helical gears — Part 21: Calculation of scuffing load capacity — Integral temperature method
60.60 Standard published
Calculation of load capacity of spur and helical gears — Part 22: Calculation of micropitting load capacity
90.60 Close of review
Calculation of load capacity of spur and helical gears — Part 4: Calculation of tooth flank fracture load capacity
90.60 Close of review
Lubricants, industrial oils and related products (Class L) — Family D (Compressors) — Part 2: Specifications of categories DAG, DAH and DAJ (Lubricants for flooded rotary air compressors)
60.60 Standard published
Microbiology of food and animal feed — Horizontal method for the detection, enumeration and serotyping of Salmonella — Part 2: Enumeration by a miniaturized most probable number technique
90.93 Standard confirmed
Milk and milk products — Determination of lead content — Graphite furnace atomic absorption spectrometric method
90.93 Standard confirmed
Plastics piping systems for soil and waste discharge (low and high temperature) inside buildings — Thermoplastics — Recommended practice for installation
90.60 Close of review