Below is a listing of projects past and present carried out by the Saint Lucia Bureau of Standards.
Health informatics — Categorial structure for representation of traditional Chinese medicine clinical decision support system
60.60 Standard published
Road vehicles — Anti-fog coating for exterior lighting devices — Specification
60.60 Standard published
Quality management systems — Particular requirements for the application of ISO 9001:2015 for electoral organizations at all levels of government
90.60 Close of review
Asset management — Guidance on the alignment of financial and non-financial functions in asset management
60.60 Standard published
Health informatics — Traditional Chinese medicine — Labelling metadata of human biological sample information
60.60 Standard published
Soil and water quality — Guidance and requirements for designing an interlaboratory trial for validation of biotests
60.60 Standard published
Reaction to fire tests — Spread of flame — Part 1: Guidance on flame spread
90.93 Standard confirmed
Reaction-to-fire tests — Heat release, smoke production and mass loss rate — Part 3: Guidance on measurement
90.60 Close of review
Reaction-to-fire tests — Heat release, smoke production and mass loss rate — Part 4: Measurement of low levels of heat release
90.93 Standard confirmed
Reaction-to-fire tests — Heat release, smoke production and mass loss rate — Part 5: Heat release rate (cone calorimeter method) and smoke production rate (dynamic measurement) under reduced oxygen atmospheres
60.60 Standard published
Water quality — Sampling — Part 25: Guideline on the validation of the storage time of water samples
60.60 Standard published
In vitro diagnostic test systems — Requirements and recommendations for detection of severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2) by nucleic acid amplification methods
60.60 Standard published
Steel and steel products — Vocabulary relating to chemical analysis
60.60 Standard published
Traditional Chinese medicine — Categorial structure for disorders
60.60 Standard published
Calculation of load capacity of spur and helical gears — Part 20: Calculation of scuffing load capacity (also applicable to bevel and hypoid gears) — Flash temperature method
90.92 Standard to be revised
Calculation of load capacity of spur and helical gears — Part 20: Calculation of scuffing load capacity — Flash temperature method
60.60 Standard published
Calculation of load capacity of spur and helical gears — Part 21: Calculation of scuffing load capacity (also applicable to bevel and hypoid gears) — Integral temperature method
90.92 Standard to be revised
Calculation of load capacity of spur and helical gears — Part 21: Calculation of scuffing load capacity — Integral temperature method
60.60 Standard published