Below is a listing of projects past and present carried out by the Saint Lucia Bureau of Standards.
Non-destructive testing of steel tubes — Part 8: Automated ultrasonic testing of seamless and welded steel tubes for the detection of laminar imperfections — Amendment 1: Change acceptance criteria
60.60 Standard published
Non-destructive testing of steel tubes — Part 9: Automated ultrasonic testing for the detection of laminar imperfections in strip/plate used for the manufacture of welded steel tubes
90.60 Close of review
Non-destructive testing of steel tubes — Part 9: Automated ultrasonic testing for the detection of laminar imperfections in strip/plate used for the manufacture of welded steel tubes — Amendment 1: Change acceptance criteria
60.60 Standard published
Rough-terrain trucks — Safety requirements and verification — Part 1: Variable-reach trucks
60.60 Standard published
Rough-terrain trucks — Safety requirements and verification — Part 2: Slewing trucks
90.92 Standard to be revised
Rough-terrain trucks — Safety requirements and verification — Part 4: Additional requirements for variable-reach trucks handling freely suspended loads
90.93 Standard confirmed
Rough-terrain trucks — Safety requirements and verification — Part 5: Interface between rough-terrain truck and integrated personnel work platform
90.93 Standard confirmed
Rough-terrain trucks — Safety requirements and verification — Part 6: Tilting operator's cabs
90.93 Standard confirmed
Rough-terrain trucks — Safety requirements and verification — Part 6: Tilting operator's cabs — Amendment 1
60.60 Standard published
Rough-terrain trucks — Safety requirements and verification — Part 7: Longitudinal load moment systems
90.93 Standard confirmed
Collets for tool holders with taper ratio 1:10 — Collets, holders, nuts
90.60 Close of review
High-speed steel two-flute twist drills — Technical specifications
90.93 Standard confirmed
Fibre-cement corrugated sheets and fittings for roofing and cladding
90.60 Close of review
Tools for moulding — Locating rings — Part 1: Locating rings for mounting without thermal insulating sheets in small or medium moulds (types A and B)
90.93 Standard confirmed
Tools for moulding — Locating rings — Part 2: Locating rings for mounting with thermal insulating sheets in small or medium moulds (types C and D)
90.93 Standard confirmed
Classification and designation of approximate chip control zones for indexable inserts with chipbreakers
90.93 Standard confirmed