Below is a listing of projects past and present carried out by the Saint Lucia Bureau of Standards.
Textiles — Tear properties of fabrics — Part 3: Determination of tear force of wing-shaped test specimens (Single tear method)
90.60 Close of review
Textiles — Tear properties of fabrics — Part 4: Determination of tear force of tongue-shaped test specimens (Double tear test)
90.60 Close of review
Textiles — Bursting properties of fabrics — Part 1: Hydraulic method for determination of bursting strength and bursting distension
60.60 Standard published
Textiles — Bursting properties of fabrics — Part 2: Pneumatic method for determination of bursting strength and bursting distension
60.60 Standard published
Foil bearings — Performance testing of foil journal bearings — Testing of static load capacity, friction coefficient and lifetime
60.60 Standard published
Health informatics — System of concepts to support continuity of care
90.92 Standard to be revised
Bonded abrasive products — Limit deviations and run-out tolerances
60.60 Standard published
Lubricated metal-powder mixes — Determination of lubricant content — Soxhlet extraction method
90.93 Standard confirmed
Metallic powders — Test method for the determination of non-metallic inclusions in metal powders using a powder-forged specimen
90.92 Standard to be revised
Diesel engines — Fuel injection pumps and fuel injector low-pressure connections — Part 1: Threaded connections
90.93 Standard confirmed
Diesel engines — Fuel injection pumps and fuel injector low-pressure connections — Part 2: Non-threaded (push-on) connections
90.93 Standard confirmed
Plastics pipes and fittings — Automatic recognition systems for electrofusion joints
90.93 Standard confirmed
Plastics pipes and fittings — Automatic recognition systems for electrofusion joints — Technical Corrigendum 1
60.60 Standard published
Plastics piping systems — Test method for the resistance of plastic pipe/pipe or pipe/fitting assemblies to tensile loading
90.93 Standard confirmed
Polyethylene (PE) pipes and fittings — Determination of the tensile strength and failure mode of test pieces from a butt-fused joint
90.93 Standard confirmed
Polyethylene (PE) pipes and fittings — Determination of the tensile strength and failure mode of test pieces from a butt-fused joint — Amendment 1
60.60 Standard published
Plastics pipes and fittings — Peel decohesion test for polyethylene (PE) electrofusion assemblies of nominal outside diameter greater than or equal to 90 mm
90.93 Standard confirmed