Below is a listing of projects past and present carried out by the Saint Lucia Bureau of Standards.
Plain bearings — Hydrodynamic plain thrust pad bearings under steady-state conditions — Part 1: Calculation of thrust pad bearings
60.60 Standard published
Plain bearings — Hydrodynamic plain thrust pad bearings under steady-state conditions — Part 2: Functions for the calculation of thrust pad bearings
90.92 Standard to be revised
Plain bearings — Hydrodynamic plain thrust pad bearings under steady-state conditions — Part 3: Guide values for the calculation of thrust pad bearings
60.60 Standard published
Plain bearings — Quality assurance of thin-walled half bearings — Design FMEA
90.92 Standard to be revised
Small craft — Carbon monoxide (CO) detection systems and alarms
60.60 Standard published
Metallic materials — Unified method of test for the determination of quasistatic fracture toughness
90.92 Standard to be revised
Reaction to fire tests — Measurement of material properties using a fire propagation apparatus
90.60 Close of review
Textiles — Domestic laundering procedures for textile fabrics prior to flammability testing
90.60 Close of review
Agricultural trailers and trailed equipment — Drawbar jacks — Part 1: Design safety, test methods and acceptance criteria
60.60 Standard published
Agricultural trailers and trailed equipment — Drawbar jacks — Part 2: Application safety, test methods and acceptance criteria
60.60 Standard published
Stationary source emissions — Determination of mass concentration of particulate matter (dust) at low concentrations — Manual gravimetric method
90.92 Standard to be revised
Virgin cork, raw reproduction cork, ramassage, gleanings, burnt cork, corkwaste, boiled cork pieces and raw corkwaste — Definitions and packaging
90.60 Close of review
Connections for hydraulic fluid power and general use — Hose fittings — Part 1: Hose fittings with ISO 8434-3 O-ring face seal ends
90.92 Standard to be revised
Connections for hydraulic fluid power and general use — Hose fittings — Part 1: Hose fittings with ISO 8434-3 O-ring face seal ends — Amendment 1
60.60 Standard published
Connections for hydraulic fluid power and general use — Hose fittings — Part 2: Hose fittings with ISO 8434-1 24° cone connector ends with O-rings
60.00 Standard under publication
Connections for hydraulic fluid power and general use — Hose fittings — Part 2: Hose fittings with ISO 8434-1 and ISO 8434-4 24 degree cone connector ends with O-rings
90.92 Standard to be revised